Ubiquiti RouterStation

MIPS Wireless Router Boards, siehe http://wiki.ubnt.com/wiki/index.php/RouterStation

Überblick

Hardware

• MIPS-Architektur, Atheros AR71xx SoC

Schnittstellen

• eth0 = WAN-Schnittstelle (einzelner POE-Port)
• eth1 = LAN-Schnittstelle (2-Port-Switch)
• wifi0 = WLAN-Schnittstelle (SLOT_0 oben)
• wifi1 = WLAN-Schnittstelle (SLOT_1 oben)
• wifi2 = WLAN-Schnittstelle (SLOT_2 unten)

Serial

• 3.3 Volt (Level-Shifter notwendig)
• J3 (3-Pin Connector), Pinbelegung:

2 - ORANGE (Signal IN/RX), 
5 - YELLOW (Signal OUT/TX), 
6 - BLACK (GROUND)

Erstinstallation

Hinweise siehe http://wiki.ubnt.com/wiki/index.php/RouterStation_OpenWRT_SW_Setup_Guide

Softwareupdate

• Image Download ("openwrt-ar71xx-ubnt-rs...bin") - http://downloads.openwrt.org/snapshots/trunk/ar71xx/
• TFTP Server aktivieren - http://uavideas.blogspot.com/2009/07/upgrade-ubiquiti-routerstation-openwrt.html

Opennet Router

• /etc/config/network

config interface loopback
       option ifname   lo
       option proto    static
       option ipaddr   127.0.0.1
       option netmask  255.0.0.0
config interface lan
       option ifname   eth1
       # option type   bridge
       option proto    static
       option ipaddr   172.16.0.1
       option netmask  255.255.255.0
config interface wan
       option ifname   eth0
       option proto    dhcp

• /etc/config/wireless

config wifi-device  radio0
       option type     mac80211
       option country  de
       option channel  100
       option hwmode   11a
config wifi-iface
       option device   radio0
       option network  wifi0 
       option mode     ad-hoc
       option ssid     olsr.opennet-initiative.de 
       option encryption none